stu wrote:Hi Bob - do you use the to hold everything square until you put on larger clamps?
I did a dry fit with pipe clamps holding the dovetail joints where I wanted them (these were cut a tad too deep
) and then fitted the corner jigs.
Then when I took it apart to apply glue, I left each corner jig in place with one clamp which made life even easier on re-assembly. I had a base and two ends firmly clamped at 90 degrees and then could add the top only having to check the depth of the DTs
These jigs avoid the need for any diagonal persuaders which for me always seem to get is the way of the other clamps.
Will we see this sort of jig in use in a local "pro" shop in future maybe?