Table Saw
Posted: 12 Jan 2016, 07:07
After a long wait I was able to welcome a new addition to my workshop!
I'm very excited by the new possibilities this opens up to me! It seems to be a Grizzly G1022Z (probably a clone, but the images look very similar), I got it 2nd hand for a bargain, so it does need a bit of attention, but it seems to be designed to last with most parts being serviceable. It also looks to be much more sturdy and built to a higher standard then the newly available entry level saws (and at a fraction of the price might I add).
I will first have to give it a good clean, and then make sure the blade is properly aligned, but I'm very excited to get going!
Any advice would be greatly appreciated!
I'm very excited by the new possibilities this opens up to me! It seems to be a Grizzly G1022Z (probably a clone, but the images look very similar), I got it 2nd hand for a bargain, so it does need a bit of attention, but it seems to be designed to last with most parts being serviceable. It also looks to be much more sturdy and built to a higher standard then the newly available entry level saws (and at a fraction of the price might I add).
I will first have to give it a good clean, and then make sure the blade is properly aligned, but I'm very excited to get going!
Any advice would be greatly appreciated!