They hold the whole motor together often passing right through from end to end.
Older motors can some times have brass nuts which are easy to strip if over tightened hence my comment.
They need to be tight but not "popeye" tight!
Don't panic!
Bob
It is currently 29 Mar 2024, 16:07
Andyp wrote:I'd eat my hat if there was not someone around here who could turn a thread on the end of a bar for you especially as you have a sample to work from.
Wizard9999 wrote:Thanks Bob, a gent as ever.
The bar is 0.375 inches diameter, i.e. 3/8" shall I get hold of some of that or is it easier for you to source it and then tell me what I owe you?
Thanks again,
Terry.
9fingers wrote:If is not too much of a personal question, how big is the knob and I'll find something appropriate.
Return to Machines & Power Toolery
Users browsing this forum: No registered users and 10 guests