It is currently 03 Mar 2024, 19:38

Wouldn't it be great if ....

Here's the place to talk about all your table saws, bandsaws, routers and dust extractors. In fact anything that makes noise and uses electrickery.

Wouldn't it be great if ....

Postby RogerS » 06 Nov 2023, 19:17

Having just finished fitting a load of skirting, because some of the archtraves were not 100% vertical, the ends of the skirting needed tweaking to a small angle off square. But on my smaller Kapex , trying to nudge the saw round a smidgeon is really difficult. Maybe it's done up too tight? Dunno and not had the opportunity to check.

But ...wouldn't it be great if you could 'call up' a fine-adjuster ...bit like the mitre adjustment on the larger Kapex. Rather than thumping it with the heel of your hand. ooops...too much.
If opportunity doesn't knock, build a door.
User avatar
RogerS
Petrified Pine
 
Posts: 13247
Joined: 21 Jul 2014, 21:07
Location: Nearly finished. OK OK...call me Pinocchio.
Name:

Re: Wouldn't it be great if ....

Postby Trevanion » 06 Nov 2023, 20:20

Trying to get an accurate cut a degree off the positive stops on a mitre saw is always a pain, slithers of timber packed between the workpiece to be cut and the fence of the saw works quite well instead.
Image
User avatar
Trevanion
Old Oak
 
Posts: 2149
Joined: 27 Apr 2019, 19:04
Location: Pembrokeshire
Name:


Return to Machines & Power Toolery

Who is online

Users browsing this forum: No registered users and 3 guests