Page 1 of 1

Two more from the shed

PostPosted: 12 Jul 2018, 18:15
by Dalboy
The first Made from Oak and decorated with acrylic artist paint on the inside and Ebonising spray on the outside It stand 6" X 3". I made a router jig and used that to produce both the upright and slots around the circumference.

DSCF0306 (593x800).jpg
(63.77 KiB)


DSCF0292 (565x800).jpg
(66.69 KiB)



The second is a small hollow form 3" X 4 3/4" with an 1/2" hole sanded inside and out to 400grit then textured on the outside finished with ebonising spray and dry brushed with pink iridescent paint Ok I know it does not look pink

DSCF0319 (800x565).jpg
(69.89 KiB)


DSCF0320 (800x596).jpg
(69.98 KiB)

Re: Two more from the shed

PostPosted: 12 Jul 2018, 19:05
by DaveL
Pink, the new blue!

I like the hollow form, something I have never tried to turn, yet.

Re: Two more from the shed

PostPosted: 12 Jul 2018, 20:09
by Malc2098
Oh, I say!

Re: Two more from the shed

PostPosted: 13 Jul 2018, 14:19
by TrimTheKing
Very nice mate. How have you done the texturing, just freehand with a gouge?

Re: Two more from the shed

PostPosted: 13 Jul 2018, 16:48
by Dalboy
Thank you guys.

Mark the texturing was done with THIS with the drill attachment and one of THESE

Re: Two more from the shed

PostPosted: 14 Jul 2018, 11:19
by Andyp
Looks like the router jig is working as planned.

Re: Two more from the shed

PostPosted: 14 Jul 2018, 16:42
by Dalboy
Andyp wrote:Looks like the router jig is working as planned.


I did have problems to start with but soon found out how to best use it. Now that will open up a few possibilities for decoration