It is currently 29 Mar 2024, 15:48
legoman0 wrote:.......Is it possible to plug the screw holes in-situ?.......
legoman0 wrote:
I'd say screws are about 5mm from surface. They could be made deeper as its a rebated frame 32mm thick.
Plug cutter - https://www.toolstation.com/titanium-pl ... set/p72650 something like that?
Thanks
Andyp wrote:.......I a bit concerned if 5mm is deep enough for such a plug.
Mike Jordan wrote:As suggested the only difficult part of plugging the screw holes is locating the drill used to counterbore the hole after removing the screw....
Mike.
Mike Jordan wrote:I thought those were intended for metal sheet cutting. I don't think they will compare to the sharp edged hole made by a Forster bit, the main drawback seems to be that it won't drill a parallel hole 10 mm deep but I must agree that it's self centring.
Mike G wrote:How deep is each step, Roger? If it is only one or 2mm then that will only lead to cock-ups. If it is 5 or 6, then it's got a chance. Remember this is going to be used whilst kneeling on the floor using a hand-held drill horizontally. Mike Jordan's suggestion is the way I'd be going, although holding the guide block in place won't be easy.
Users browsing this forum: No registered users and 5 guests