It is currently 28 Mar 2024, 23:30
9fingers wrote:The table interests me too as it looks as if it would be nigh on impossible to assemble.
Bob
Dave R wrote:The joints would have to be cut to close tolerances but I expect once the joint is glued up, it would be as rigid as a mortise and tenon joint.
TrimTheKing wrote:I like the table. Not so keen on your stool samples...!
Mark
DaveL wrote:TrimTheKing wrote:I like the table. Not so keen on your stool samples...!
Mark
I like the stools but not the table, that evens things out a bit.
Dave R wrote:You guys make me laugh.
Rod wrote:You could cheat and make the "leg top" a mortice and tenon cap?
Rod
Dave R wrote:Rod wrote:You could cheat and make the "leg top" a mortice and tenon cap?
Rod
True.
I guess I don't see that the way the original was made is so difficult. A dado stack on the tablesaw would make quick work of it.
Return to SketchUp & other 'CAD' Tools
Users browsing this forum: No registered users and 6 guests