It is currently 29 Mar 2024, 10:51
Tusses wrote:Long time since I looked at them, but can you get "riv nuts" that size ?
Robert wrote:I'd forget the existing holes and drill one new one half way between them then fit a self tapper screw. job done.
DaveL wrote:Robert wrote:I'd forget the existing holes and drill one new one half way between them then fit a self tapper screw. job done.
I think the box has thin sides with the corners filled in to give enough metal to be drilled and tapped.
Buy a set of taps and the fill the striped holes with car body filer, then redrill and tap them, would be my solution.
9fingers wrote:Woo hoo 7.5 horses under the table eh? Proper job!!
Bob
9fingers wrote:No those all fla running currents. Quite a bit more for starting inrush. Make sure you fit type c mcbs in your fuse board to avoid nuisance trips on start up. There are soft start solutions if you get desperate but cost!!!
Bob
9fingers wrote:Not really a good analogy
Just keep a blade spinning takes very little power. Feeding lumps of wood through absorbs lots of power and it is power that you pay for.
Bob
Return to Machines & Power Toolery
Users browsing this forum: No registered users and 12 guests