It is currently 30 Mar 2024, 05:02
RogerS wrote:Can't involve a third party. We're paying the removal people enough money. It's their job.
Tusses wrote:Can involve a third party. We're paying the removal people enough money. It's their job......... But !! it's My stuff !!
Tusses wrote:RogerS wrote:Can't involve a third party. We're paying the removal people enough money. It's their job.
orTusses wrote:Can involve a third party. We're paying the removal people enough money. It's their job......... But !! it's My stuff !!
I'd be happier knowing I'd get it in one piece, rather than it was "someone else's fault" !
Else you might as well sell it, and buy another after the move
9fingers wrote:.....
Taking them off fixes that risk but depending on the design, P/T can be a real b'std to refit the tables and tune it up to plane true again.
Good Luck
Bob
Wizard9999 wrote:But do you of table above thicknesser table as suggested so you are bearing on the cutter block? I would have thought you would raise the table first and put timber under the table. Sure my Startrite's manual is handy when I get home and I know it covers that.
Terry.
9fingers wrote:Wizard9999 wrote:But do you of table above thicknesser table as suggested so you are bearing on the cutter block? I would have thought you would raise the table first and put timber under the table. Sure my Startrite's manual is handy when I get home and I know it covers that.
Terry.
Timber above the table shares the load between the feed rollers and the cutter block. Below the table could be dodgy depending on the machine design. I had a kity once that only had a pressed steel thicknesser table and that would have been wrecked by such a method.
Other machines sometime have a strong enough table but it rises on a central column which could be vulnerable.
Bob
Jimmy Mack wrote:.....
I've taken the tables off in the past ...the in-feed is an absolute pig to get back on...(and that was with two people!).....
Jim
Sent from my HTC 0P6B900 using Tapatalk
RogerS wrote:Jimmy Mack wrote:.....
I've taken the tables off in the past ...the in-feed is an absolute pig to get back on...(and that was with two people!).....
Jim
Sent from my HTC 0P6B900 using Tapatalk
Many thanks, Jim. I feel quite chuffed reading this as I agree with you. Getting the infeed table back on is a pig and I did mine all on my little ownsome
Users browsing this forum: No registered users and 7 guests