Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
Yep, this place. Fantastic range of sizes and materials...I went there a couple of times when we were visiting No.1 daughter in Carlisle - Rob
It is currently 28 Mar 2024, 18:27
Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
Woodbloke wrote:Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
Yep, this place. Fantastic range of sizes and materials...I went there a couple of times when we were visiting No.1 daughter in Carlisle - Rob
Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
9fingers wrote:Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
I've one of those Veritas "pencil sharpener" type dowel makers for 3/8".
I could make you some if you like Malc?
Bob
TrimTheKing wrote:9fingers wrote:Malc2098 wrote:Can anyone recommend any good hardwood dowel suppliers?
I've one of those Veritas "pencil sharpener" type dowel makers for 3/8".
I could make you some if you like Malc?
Bob
And I've got loads of scraps of ABW I could send to Bob to make them from if you wanted real contrast...
Malc2098 wrote:I'll get the exact measurements in the morning.
Malc2098 wrote:9fingers wrote:What is the theory behind that process?
Bob
I've no idea. Like Roger said, It seem counterintuitive. You'll have to ask him!
RogerS wrote: Rob...is she still in Carlisle ?
Malc2098 wrote:Morning, Bob.
The feet are 85mm which and the top rails are 60 mm thick.
9fingers wrote:Malc2098 wrote:Morning, Bob.
The feet are 85mm which and the top rails are 60 mm thick.
So about 1.5 m should be plenty then?
Over to you mr T
Bob
Malc2098 wrote:Thanks, Bob.
Yes, I realised I'd need an imperial bit or forstner.
G&S do a 150mm long 3/8" forstner.
I'm struggling to find long imperial drill bits.
9fingers wrote:Malc2098 wrote:Thanks, Bob.
Yes, I realised I'd need an imperial bit or forstner.
G&S do a 150mm long 3/8" forstner.
I'm struggling to find long imperial drill bits.
Axi do 3/8" drills - you only need 85 mm plus a bit for the chuck should be within the scope of a standard drill length?
Bob
Phil wrote:Coming along nicely Malc.
Users browsing this forum: No registered users and 13 guests