Page 1 of 1

A pair of box's

PostPosted: 14 Oct 2021, 15:12
by fiveeyes
DSC_0131.JPG
fitted and glued
(315.41 KiB)
DSC_0120.JPG
bead was hand fitted using chisel's, and a guide block...satisfying
(263.37 KiB)
DSC_0118.JPG
(233.48 KiB)
DSC_0115.JPG
having decided on size and shape, and made 4 sides, I wanted a drawer. I used a multi-tool to cut out the drawer face. I did not get the 1mm gap as intended, so had to get the opening squared up.
(271.55 KiB)


The order is reversed obviously. how to fix that will be helpful. tia mor later

Re: A pair of box's

PostPosted: 14 Oct 2021, 19:18
by 9fingers
Putting the correct photo with the matching text is a matter of placing the cursor in you text where you want the photo and then select the photo and hit "place in line"

Make sure you place all the photos that you have uploaded other wise the unplaced ones pile up at the bottom of the post bordered by dotted lines.

HTH
Bob

Re: A pair of box's

PostPosted: 14 Oct 2021, 20:02
by Cabinetman
And if you’re as hopeless at it as I am, select your photos in reverse order to start with then they will be the right way round to put them in your amongst your text, or name the photos otherwise you just get a line of numbers that relate to the photo but don’t tell you what the photo shows! :lol:
I think the bead around the drawer is a really nice touch, good proportions as well.

Re: A pair of box's

PostPosted: 23 Oct 2021, 13:58
by fiveeyes
DSC_0137.JPG
this shows assembly, and fitting the tray, and drawer..drawer has temporary 'pulls' it was a 'piston fit'
(285.16 KiB)
DSC_0127.JPG
frame assembly..feet in 'clamps'
(307.06 KiB)
DSC_0129.JPG
this is how I made the feet for the base, small parts need a handle, so, make a blank..bevel the ends on opposite sides..so one ends up with lefts, and rights..attach the template, bandsaw to rough,finish on router table. then saw off the four corners(feet)..assemble, and glue to the base frame
(233.82 KiB)
A few more...