It is currently 29 Mar 2024, 00:19
Dr.Al wrote: I'm not sure it's really necessary...
Lurker wrote:Dr.Al wrote: I'm not sure it's really necessary...
Not stopped you before
9fingers wrote:I've coded some of my allen keys using wiring sleeves and the international resistor colour code which is burned into my brain since childhood experimentation with electronics. Leads to an instant association of a colour with digits 0-9
eg orange, orange, red for 3/32" brown,grey for 1/8" green orange red for 5/32" etc
works ok until oil gets to the rubber and the sleeves perish.
Bob
9fingers wrote:It's impressive how they fit all the ohms into modern micro-miniature resistors that are even too small to have colour coding and I need a microscope to read the numbers!
Lons wrote:I'm going to put you on ignore Al if you don't stop it at once.
My missus has just asked for ideas for the kids to buy me for Christmas and I had huge problems resisting a contribution to one of those plastic makey trickery gizmos.
I shall write in old fashioned pencil 50 lines of " I don't NEED a 3D printer." ( Do schoolkids still get lines to write if they've been naughty? )
Mike G wrote:How do you prevent that rotating around the shaft, and how do you ensure it is exactly horizontal? Obviously any deviation from horizontal would result in out-of-square grinding.
Return to SketchUp & other 'CAD' Tools
Users browsing this forum: No registered users and 6 guests